Tanzanite colored mineral necklace
design by Kimura Premium

Productsʼ information above is updated in Novebmer 2023.

【Material】
UV-LED Resin Star Drop Hard
Jewel Color Birthstone Color Set［7-12］
Tafrect Mold［Mineral D］
UV-LED Lamp
Handy Heater
Mixing Palette
Mixing Stick
Shading Case
Resin Cleaner
（ethanol diluted 2x with water)
Pearl beads
Neck chain
T pins
Eye pins
Jump rings
Earing parts
Pin Vise
Tweezers
Pliers
Nippers

  1. 1.

    Put drops of tanzanite color into star drop resin.

  2. 2.

    Mix it well with a stick.

  3. 3.

    Use a handy heater to remove air bubbles.

  4. 4.

    Place in a case to prevent exposed to light and cool it down.

  5. 5.

    Pour the green resin into the mineral D-a mold.

  6. 6.

    Cure it under UV-LED lamp.

  7. 7.

    Cool it down first, then soak the cleaner between the mold and the resin to make it easier to remove.

  8. 8.

    Make a same shaped ore with clear color resin.

  9. 9.

    Fasten the pearl beads through T-pins.

  10. 10.

    Drill holes in the same position in the two stones.

  11. 11.

    Pass 9 pin through the hole and round the tip. Then, attach a pearl to it with a jump ring.

  12. 12.

    Connect the stone to the neck chain with a jump ring.

Go Back