Joy of Creation.

Pour Sun Drop Resin into a palette. Add a few drops of your preferred pigment to the resin.

Mix thoroughly with a stick.

Place the palette in a shading case and close the lid for 30 minutes to allow air bubbles to dissipate.

Pour the resin into the lower half of the mold. Use a stick to gently guide the resin into the corners, ensuring it spreads evenly throughout.

Pour clear resin into the upper half of the mold, filling it up to the top.

Using tweezers, carefully insert the foot of a cranked eye pin and position it at the top edge of the mold.

Cure the resin under a UV-LED lamp.

Then, cure it again from the backside of the mold.

After cooling down, gently push the cured piece out with your finger. Avoid pulling on the eye pin.

Open a jump ring with a pair of nose pliers and thread it through the eye pin.

Attach an earring part to the jump ring and close it securely.

One earring is ready.