Joy of Creation.

Prepare two colored resin. Pour resin in two palettes and put drops of color you like into each resin. Stir colored resins well with a stir stick.

Use a handy heater to remove air bubbles.

Place one palette in a shading case to avoid exposure to light.

Hold an 8mm-cut stick with tweezers and dip both tips of the stick a bit into the colored resin.

Set the stick with resin and float it on the inside top of the tafrect mold_mineral B.

Fix the stick by placing the mold under the light.

Scoop the resin and place it into the mold with a mixing stick. Be careful not to take the fixed stick off by hitting it..

Cure it under the UV-LED light.

Cool the mold down, soak the cleaner in, rub the mold from the back, then pull the stone out.
※The key to long-lasting mold.

Push the stick from both sides using a round nose pliers. Once the stick moves and comes out, pull it out by hands.

Put a plier in the hole and turn it to the left or right to widen the hole. Scrape off burrs. Repeat the process from step 4 for other stone.

Take off the C-ring on one side of the necklace, insert the wire and put the stones through the wire.