Rose Petal Button Ring
design by SIS

【Material】
UV-LED Resin "Star Drop" hard
Jewel color white
Embroidery floss
Rose petals
Pad finger ring

【Tool】
Glue
Dry sheet
UV-LED handy light
Soft mold button
Weight book
Mixing stick
Mixing palette

RECIPE PDF
  1. 1.

    Refer to RECIPE PDF, make the pressed flowers with rose petals.

  2. 2.

    Add a layer of resin in mold and cure it in 30 seconds.

  3. 3.

    Set rose petals.

  4. 4.

    Add resin to cover petals and cure in a minute.

  5. 5.

    Make white color resin adding 1 - 2 drops of jewel color white.

  6. 6.

    Add white resin into mold.

  7. 7.

    Cure in 1minute. Turn it over, cure in a minute again.

  8. 8.

    After cooling down, take it out. Thread the button with floss. Tie on the back.

  9. 9.

    Glue the ring on the back side of button. Rose button ring is done.

Go Back