Cherry Blossom Hair Pin

Productsʼ information above is updated in February 2021.

【Material】
UV-LED Resin "Star Drop" Hard and the Soft one (item#403236/303280, 403245)
Jewel Color Pink and White (#403034/403045)
UV-LED light (#403284)
Silicone Mold Hydrangea (#403287)
Mixing Palette (#403032)
Mixing Stick (#403033)
Bullion/gold beads 3mm x 3 pieces
Bobby Pin with circle pad blank base
Clear sheet /plastic file holder cut in small
Scissors
Tweezers

RECIPE PDF
  1. 1.

    Make cherry blossom colored resin with UV-LED SOFT putting a drop of pink and white liquid color.

  2. 2.

    Use PADICO Silicone Mold "Hydrangea". Pour the pink resin in the largest petal and cure it under the UV-LED light.

  3. 3.

    Repeat the step 2 for 4 times to make 5 petals.

  4. 4.

    Make a V-shaped cut on a petal with scissors. Use the blade close to the handle of scissors for easy cut.

  5. 5.

    Repeat step 4 for other petals.

  6. 6.

    Set petals overlapping each other on a plastic file holder.

  7. 7.

    Put a drop of UV-LED Resin Hard at the center of the flower.

  8. 8.

    Arrange 3 bullions on the resin.

  9. 9.

    Cure it in 30 ‒ 60 seconds.

  10. 10.

    Put certain amount of UV-LED Resin Hard on the circle pad base of the pin and set the flower on. Cure the pin under the UV-LED light.

  11. 11.

    Turn the pin over and paste the resin on the back side of the flower.

  12. 12.

    Harden the back side and turn it back to the front, then cure it again for sure.

Go Back